Insta360
Insta360 Standard Motorcycle U-Bolt Mount
Insta360 Standard Motorcycle U-Bolt Mount
SKU:FM24IMU
Couldn't load pickup availability
A more stable, reliable design for unbeatable on-board footage. Use it with the Insta360 Action Invisible Selfie Stick to capture incredible third-person footage of your motorbike - truly blockbuster potential.
Properties:
- Updated design with a new, patented gimbal structure that provides unprecedented stability for motorcycle shots.
- Completely new design for more stable onboard third-person shots.
- Applicable to most mainstream motorcycles.
- Standard 1/4" adapter design, supports Insta360 Action Invisible Selfie Stick.
- GO 2 must be assembled with the Action Mount adapter.
Specifications:
Weight: 201g
Dimensions: 96.5x51.5x57mm
Compatible with: Ace Pro, Ace, X3, ONE RS (Twin/4K),GO 2, ONE X2, ONE R, ONE X
Notes:
The spacer should be installed inside the U-bolt based on the clamping position and size.
Tighten the universal joint securely on the U-bolt before use.
The supplied washer pairs consist of two sets of washers. Be careful not to lose them during disassembly, as losing a washer could cause the nut to loosen due to vibration.
The U-Bolt can be mounted on the motorcycle frame, rear pedal holder, bumper and other secure locations. Always check that the U-Bolt is securely in place and that there is no rotation or play in the attachment.
Motorcycling is recommended only on smooth roads, at speeds not exceeding 80km/h (50mph). Off-road riding is not supported.
It is recommended to connect the Insta360 Action Invisible Selfie Stick to the universal joint with the 1/4" adapter to securely attach the stick. Please do not connect the selfie stick to other accessories. Please do not twist the top of the selfie stick forcefully, as excessive torque may damage the universal joint.
If the motorcycle is parked outside for an extended period of time, remove the accessories to keep them in the best condition.
Please use the accessory according to the installation method in this user manual, do not do it yourself. Any damage caused by failure to follow the instructions is not covered by Insta360's warranty or replacement service.
Content:
- 1x universal joint
- 1x U-bolt
- 1x wrench
- 1x hex key
- 1x large spacer
- 1x Small spacer
- 2x rubber pads
- 2x pair of washers
- 1x thumb screw
- 1x 3-pin adapter to 1/4" adapter
- 4x anti-slip rings
Share

